:	Aug 5, 2004

.

Disconnect the battery ground cable.

.

Remove and discard the timing belt.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the special tool.

.

Remove the special tool.

.

Install the special tool.

.

Loosen the crankshaft pulley retaining bolt.

.

Using a suitable tool, release the crankshaft pulley.

.

Remove the crankshaft pulley.   Remove the crankshaft pulley retaining bolt.   Discard the bolt.

.

Install the special tool to the crankshaft.

.

Using the special tool, remove the crankshaft front seal.   Remove the special tool.   Remove and discard the seal from the special tool.

.

: Do not use any lubricant on the crankshaft front seal, special tools or the crankshaft. Failure to follow this instruction may result in damage to the vehicle. :   Make sure all component mating faces are clean. Install a new crankshaft front seal to the special tool.

.

Reposition the crankshaft front seal along the special tool.   Remove the sleeve from the special tool.

.

Install the special tool to the crankshaft.

.

Install the special tool to the crankshaft.

.

: Make sure the seal is installed correctly. Using the special tool, install the crankshaft front seal.   Use the discarded crankshaft bolt with the service tool.

.

: Make sure the seal is installed correctly. Remove the special tool.   Remove and discard the crankshaft pulley retaining bolt.

.

Install the crankshaft pulley.   Install a new crankshaft pulley retaining bolt.   Tighten the retaining bolt in two stages:   Stage one: Tighten to 100 Nm (74 lb.ft).   Stage two: Tighten a further 90 degrees.

.

Remove the special tool.

.

Install the special tool.

.

Install the special tool.

.

Install the new timing belt.

.

Connect the battery ground cable.